Лампа для випікання спін котера

Wed, 03 Jun 2026 12:32:32 +0800

Out on the line, thermal variance isn’t some abstract metric. It’s a defect looking for a place to happen. A 2°C drift during photoresist soft bake can throw off critical dimension control, and a sloppy heat profile during wafer drying is an open invitation to edge bead and particle contamination. We built our spin coater bake lamps to kill that uncertainty. What matters under the hood We run short-wave infrared emitters in a quartz lamp body, with closed-loop temperature control that holds wafer-level uniformity at ±0.1°C across the spin surface. Response is sub-second, so when you change the setpoint, the lamp follows immediately and you keep your thermal budget intact. Cleanroom compatibility isn’t an add-on; it’s engineered in for Class 1–100 environments. The assembly generates zero particles during operation, and the low-outgassing design keeps contamination out of the process chamber. Why this plays in fab and packaging Whether you’re running photoresist bakes, wafer drying, or package curing, the payoff is repeatability. Tighter temperature control means more consistent line widths, less rework, and faster changeovers. You also save energy because the lamp comes up to temperature quickly and holds it without overshoot. Reliability? These units have run 24/7 and logged 5,000+ hours with less than 5% output drop. The practical details Installation comes down to matching the lamp footprint to your coater/track tooling and verifying voltage and connector compatibility before you swap. Expect a short warm-up to stabilize output, and stick to cleanroom handling procedures during lamp changes to avoid adding particulates. Set it up right, and you get thermal performance that hits the process spec—every cycle.

Покривач on Industrial IR Heating Solutions

Лампа для випікання спін котера